It is important to remember that transformers do not
generate electrical power; they transfer electrical power from one AC circuit
to another using magnetic coupling. The core of the transformer is used to
provide a controlled path for the magnetic flux generated in the transformer by
the current flowing through the windings, which are also known as coils.
There are four primary parts to the basic transformer. The
parts include the Input Connection, the Output Connection, the Windings or
Coils and the Core.
Input Connections -
The input side of a transformer is called the primary side because the main
electrical power to be changed is connected at this point.
Output Connections -
The output side or secondary side of the transformer is where the electrical
power is sent to the load. Depending on the requirement of the load, the
incoming electric power is either increased or decreased.
Winding -
Transformers have two windings, being the primary winding and the secondary
winding. The primary winding is the coil that draws power from the source. The
secondary winding is the coil that delivers the energy at the transformed or
changed voltage to the load. Usually, these two coils are subdivided into
several coils in order to reduce the creation of flux.
Core - The
transformer core is used to provide a controlled path for the magnetic flux
generated in the transformer. The core is generally not a solid bar of steel,
rather a construction of many thin laminated steel sheets or layers. This
construction is used to help eliminate and reduce heating.
Transformers generally have one of two types of cores: Core
Type and Shell Type. These two types are distinguished from each other by the
manner in which the primary and secondary coils are place around the steel
core.
When an input voltage is applied to the primary winding,
alternating current starts to flow in the primary winding. As the current
flows, a changing magnetic field is set up in the transformer core. As this
magnetic field cuts across the secondary winding, alternating voltage is
produced in the secondary winding.
The ratio between the number of actual turns of wire in each
coil is the key in determining the type of transformer and what the output
voltage will be. The ratio between output voltage and input voltage is the same
as the ratio of the number of turns between the two windings.
A transformers output voltage is greater than the input
voltage if the secondary winding has more turns of wire than the primary
winding. The output voltage is stepped up, and considered to be a "step-up
transformer". If the secondary winding has fewer turns than the primary
winding, the output voltage is lower. This is a "step-down
transformer".
